Connect with an FHOPE Specialist +86-150-21705930

 

Effects of cutting Speed on Tool life

Effects of cutting Speed on Tool life

Effects of cutting Speed on Tool life The combination of cutting speeds at constant feeds has a tremendous significant importance on the value of tool life. In the cutting tests carried out on AISI 316 stainless steel, an increase in cutting speed at a constant feed produced a visible reduction in tool life. Looking closely at Fi...

Wear mode of processing AISI 316 stainless steel

Wear mode of processing AISI 316 stainless steel

Wear mode of processing AISI 316 stainless steel Side wear is the development of grooves at the cutting depth of both sides of the tool. This is probably due to severe (hard or oxidized) parts on the surface. This is because the original working surface is more serious than the previous work hardening and internal material wear. ...

An economic substitute for the conventional CFRP milling cutt

An economic substitute for the conventional CFRP milling cutt

In the submitted papers, the technical investigation of improving the CFRP grinding process is shown. So different methods have been carried out. One method involves the use of innovative grinding wheel specification and its influence on milling related parameters during the grinding process of end mills. The results show that di...

Comparison and analysis of the machining performance of the c

Comparison and analysis of the machining performance of the c

Comparison and analysis of the machining performance of the ceramic end milling cutter In order to evaluate wear behavior of cutting tools, the maximum width of side wear area VBmax is usually used. The marginal quality of workpiece can also be evaluated as the wear standard for CFRP material which tends to be layered and worn. I...

Development of tool geometry

Development of tool geometry

Significant differences between the specifications of the grinding wheels can also be observed on the rake face. Although the feed rates between VF = 10 mm / min and 50 mm / min are very small, the difference in the surface quality between the wheel specifications is significant for the feed speed VF = 90 mm / min. At this point ...

Development and application of ceramic end mills

Development and application of ceramic end mills

The cutting materials used in CFRP processing must meet the high wear resistance requirements, because the two phase composite structure composed of fiber and CFRP with different properties is mainly accompanied by this wear mechanism. Therefore, PCD and diamond coated carbide tools are widely used, because they show proper perfo...

Experimental device

Experimental device

Cemented carbide is widely used in cutting tool industry, and because of the brittleness of hard material, super abrasive wheel is needed. In many cases, the use of resin bonded grinding wheels, though the material removal rate Qw is limited, can achieve good surface and tip quality. In the past few years, new hybrid bonding spec...

Optimization of the flute grinding process

Optimization of the flute grinding process

As the tool grinding process has a verifiable influence on the machining behavior of cutting tools several investigations on the optimization of the flute grinding process of end mills were conducted. Therefore grinding tests with innovative grinding wheel specifications were carried out and the work result was evaluated in terms...

The superior properties of CFRPs on the other side pose a gre

The superior properties of CFRPs on the other side pose a gre

The superior properties of CFRPs on the other side pose a great challenge for tool manufacturers. As the characteristics of CFRP materials can vary widely due to different compositions of e.g. fibre types, diameters, lengths andorientations as well as the synthetic matrix specification, they show also a diverse behavior during ma...

MIlling application in aerospace industry

MIlling application in aerospace industry

In the last few decades, the aerospace industry has seen a good example of the replacement of existing materials and still in progress. A large part of the modern aircraft is made up of innovative lightweight materials such as carbon fiber reinforced plastics (CFRP) and aluminum alloys. Recently, the auto industry is also trying ...

Categories

Products

DLTTK600 series-End mill for thread

DLTUA600 series - High Speed Aluminum End Mill Machining